Essex Electronics K1 Series Manuel d'instructions télécharger pdf (Page 23)

Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com

2. Wait ve seconds for the 3 reset beeps. (Do not enter any digits

until you hear 3 reset beeps.)

 Programming Door Open Time

Default

5 seconds

To Program/Change the Door Open Time for the Master Code and

User Code 1 and 2:

1. First determine the length of time you wish to program as the

Door Open Time for these users. This is the length of time the

door will remain open after a valid Master Code, User Code 1 or

User Code 2 has been entered into the system.

Note: For controlling a garage door or electric gate, you will need

to set the door open time to 1 second

2. Locate the Control Module, remove the cover and locate the

“PROGRAM” switch on the circuit board.

3. Press the PROGRAM switch once *. (The Keypad will beep

rapidly 4 times.)

4. At the Keypad, enter 1-1-1-7 to open the memory (you will hear

three rapid beeps) and enter a combination of “1’s” (for every one

second increment) and “5’s” (for every ve second increment)

that equal your desired Door Open Time. Each valid key press (a

“1” or a “5”) will generate a double beep. (Do not let more than

ve seconds elapse between entries or the system will reset!!!

Example: “1-1-1-7 5-5-5-1-1”

17 seconds

5. After entering your Door Open Time, wait ve seconds for the 3

reset beeps.

To Program/Change the Door Open Time for User Code 3, 4, and 5

(Rev B and later):

1. First determine the length of time you wish to program as the

Door Open Time for these users. This is the length of time the

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

Essex Electronics K1 Series Manuel d'instructions Page 23